How to Practice Guitar With a Metronome

Acoustic guitar lying beside a pyramid metronome with glowing beat dots, illustrating how to practice guitar with a metronome

To practice guitar with a metronome, open the free Metronome, set a tempo slow enough that you can play cleanly, and work through a few short drills: strumming on the click, alternate picking through subdivisions, and playing with the click on beats 2 and 4. Spend a few minutes on each, then raise the tempo a little once a drill feels easy. Short, regular sessions tend to help your timing more than one long session a week.

This guide covers guitar-specific routines. If you have never used a metronome before, start with How to Use a Metronome (Beginner Guide), which walks through every control. Keyboard players have their own drills in How to Practice Piano With a Metronome.

What you'll need

  • A guitar, acoustic or electric, in tune. Tune up first with the Guitar Tuner, which runs in the same browser. A metronome and guitar tuner side by side is all the setup this routine needs. If you want help with that step, see How to Tune a Guitar With an Online Tuner.
  • A pick, for the strumming and alternate-picking drills.
  • A phone, tablet or laptop. Headphones are optional but help a lot over a loud amp.

The Metronome is free, needs no account, and has nothing to install. It generates its own click on your device, so it never asks for the microphone and doesn't take a file.

Set up the metronome for guitar practice

Any guitar metronome online will do for these drills, but the steps here use the Vocal Cut one. The setup is the same for every drill below:

  1. Set the BPM with the − and + buttons (1 BPM per press) or the tempo slider. It starts at 120 and goes from 20 to 300.
  2. Leave "Beats per bar" on 4 for most rock, pop and blues.
  3. Keep "Accent the first beat" ticked, so beat one is a higher click with an amber light.
  4. Raise the "Volume" slider until the click cuts through your guitar.
  5. Choose a "Subdivision": Quarter, Eighths, Triplets or Sixteenths. The extra clicks between beats are softer and lower.
  6. Press the amber "Start" button. It turns into "Stop".

You can change any of these while it plays. The click also keeps going if you switch tabs to a chord chart or tab, but a phone that locks its screen can pause the sound, so keep the screen awake.

Drill 1: strumming on the click

Strumming is where most guitarists first notice their timing drift, so start here with a guitar metronome set slow.

  1. Hold a chord you know well, such as G or E minor.
  2. Set Quarter subdivision and a tempo where you feel relaxed. If you're unsure, start lower than you think you need.
  3. Play one downstroke on every click. Aim for the strum to land exactly on the click, so the two sounds merge.
  4. Switch the subdivision to Eighths. Now play down on the main click and up on the softer click between.

Keep your strumming hand moving down and up the whole time, even when you skip the strings. That steady arm motion holds the rhythm together once a pattern has gaps in it. When the quarter and eighth patterns feel solid, try a common pattern like down, down-up, up-down-up, still with the arm swinging on every eighth.

Drill 2: alternate-picking drills

Alternate picking means strictly down, up, down, up. A metronome for guitar shows you whether your picking hand and fretting hand are actually landing together.

Use the classic chromatic exercise: fingers 1-2-3-4 on frets 1 to 4 of the low E string, then the same on each string up to high E, and back down.

  1. One note per click. Set Quarter subdivision and play one note on each beat, alternating the pick direction.
  2. Two notes per click. Switch to Eighths and play a note on every click, main and soft.
  3. Three notes per click. Switch to Triplets. The pick direction now flips on each beat, which is good practice for your picking hand.
  4. Four notes per click. Switch to Sixteenths. Drop the BPM first if you need to.

Listen for the pick and the fretted note sounding at the same instant. If a note buzzes or speaks late, your fretting finger arrived after the pick. Slow down until both hands sync, then build back up. The subdivision clicks give you a target for every single note, which is harder to fake than strumming.

Drill 3: clicks on 2 and 4

In most rock, pop, funk and blues, the snare drum hits beats 2 and 4. Practicing with the metronome on just those beats trains that backbeat feel and makes you supply beats 1 and 3 yourself.

The Vocal Cut Metronome has no setting to click only on chosen beats, so you do it by halving the tempo:

  1. Find the tempo you want to play at, say 100 BPM.
  2. Set the metronome to half that, 50 BPM.
  3. Set "Beats per bar" to 2.
  4. Untick "Accent the first beat" so both clicks sound the same. (Or leave it on and hear the accented click as beat 2.)
  5. Count "1 2 3 4" over two clicks, so each click lands on "2" and "4".

Now strum or play a riff over it. Because the gap between clicks is twice as long, any rushing or dragging on beats 1 and 3 shows up when you miss the next click. It feels strange for the first few minutes. Counting aloud helps until the click starts to feel like a snare.

Drill 4: chord changes and song riffs at a slower tempo

In real songs, a lot of timing trouble shows up at chord changes rather than in the middle of a strum.

  • Changes on the click. Pick two chords you find awkward. Strum four quarter notes on each and switch on beat one. Then try two beats per chord, then one.
  • Riffs from songs. To match a song's speed, tap along with it using the "Tap tempo" button. It averages up to your last six taps, and a gap of more than two seconds starts a fresh count. The tapping technique is covered in Tap Tempo BPM Finder: How to Tap Out a Song. If you have the song as a file, the BPM Finder reads the tempo for you.

Once you know the song's BPM, set the metronome well below it and learn the riff there. If you'd rather play along with the actual recording at a slower speed, see How to Slow Down Music to Practice an Instrument, which uses the Speed Changer to slow the track without changing its pitch.

How to raise the tempo

Use the same rule for every drill: only speed up when the current tempo is clean.

  1. Play the drill at your starting tempo until you can do it correctly several times in a row, with no tension in your hands or shoulders.
  2. Raise the tempo by a few BPM. Many teachers suggest small steps of a few BPM at a time, which is a handful of presses on the + button.
  3. If mistakes appear, go back to the last clean tempo and stay there for a while.

These step sizes are a teaching convention, not a formula, and some days you'll end slower than you started. Write down your best clean tempo for each drill so you have a starting point next time.

Troubleshooting

You keep rushing ahead of the click

Rushing is a common habit, often on fast strums and before a tricky change. Drop the tempo, switch on Eighths so there's a click to wait for between beats, and count aloud.

You can't hear the click over the guitar

Raise the "Volume" slider, then your device volume. On an acoustic or a loud amp, headphones fix this. Wired headphones are best, because Bluetooth can add a delay that makes the click feel late.

The click seems to disappear

If you're playing so tightly that the click is hard to hear, your strum or pick is landing right on it. That's a good sign. Check it by playing slightly off on purpose: the click should reappear.

You can only stay in time with the click on

Play a few passes with the metronome off, then turn it back on and see whether you're still with it. For more on how a click helps your timing and when to step away from it, see What Is a Metronome? Definition and Meaning.

Frequently asked questions

What BPM should I start at when practicing guitar with a metronome?

Start at whatever tempo lets you play the drill cleanly with relaxed hands, even if that's very slow. There is no single correct number. For strumming you may be comfortable faster than for sixteenth-note picking, so set a separate starting tempo for each drill and raise each one only once it feels easy.

How do I make a metronome click on 2 and 4?

Halve the song's tempo and treat each click as beat 2 or beat 4. For a song at 100 BPM, set the metronome to 50 BPM with Beats per bar on 2, untick the first-beat accent, and count 1 2 3 4 across two clicks. The Vocal Cut Metronome has no per-beat accent setting, so halving the BPM is how you get a backbeat click.

Should I use subdivisions when practicing guitar?

Yes, especially at slow tempos and for picking drills. Eighths, Triplets and Sixteenths add softer clicks between the main beats, so every note you pick has a target. They also stop you from rushing in the gaps. Once a drill is solid, try it on Quarter only to check that you can feel the subdivisions yourself.

Is there a free online metronome for guitar?

Yes. The Vocal Cut Metronome is free and runs in your browser with no account or install. It covers 20 to 300 BPM, beats per bar from 1 to 12, an accented first beat, subdivisions and tap tempo. It plays its own click and never uses your microphone. The site's Guitar Tuner is free too, so you can tune and practice in one place.

How long should I practice guitar with a metronome each day?

There is no fixed amount, but short, regular sessions tend to work better than occasional long ones. A useful routine is a few minutes on each drill: strumming, alternate picking, clicks on 2 and 4, then a song section. Stop or slow down when your hands get tense, because practicing with tension builds tension into your playing.